Ping You Industrial Co.,Ltd
SMT Equipment Spare Parts Supplier&
PCB PCBA processing and production
|Place of Origin:||China|
|Minimum Order Quantity:||1pcs|
|SMT Red Plastic:||SMT Red Plastic 120-150 Degree Curing Adhesive For Posts 30CC||Curing Temperature:||120-150°C|
|Curing Equipment:||Reflow Soldering||Place Of Origin:::||Shandong, China (Mainland)|
|Name:||No Clean Solder Paste|
Red Plastic SMT Solder Paste UV Curing Plastic Bonding Adhesives For Posts 30CC
A small sample for testing first is avaiable.
Shipped in 5 days after payment
PY36G is one component epoxy adhesive and a kind of heat cured adhesive. It designed for stencil printing . High bonding strength, high humidity ,high intensity,excellent electrical performance and good storage stability.
Mainly used for the bonding of the mounted components on SMT.
|Typical Value||Range||Test Standard|
|Chemical Type||Epoxy Resin|
|Viscosity (Pa.s)(Brookfield RV) Spindle 7||200-400||GB/T 2794-1995|
|Density (g/cm3)||1.35||1.32-1.38||GB/T 13354-1992|
Operate Time at Room Temperature(day@25°C)
Curing Condition Recommended
90-120s at 120°C.
60-90s at 150°C
The product will obtain to higher bonding strength when higher curing temperature and longer cured time . the figure curve is the recommended curing temperature and heating rate,Underthe corresponding temperature ,components need the time when they achieve good bonding strength.
Users can set the curing furnace’s temperature parameters according to the solidified characteristic curve of the glue and the heat efficiency of the Reflow Ovens
Performance After Cured
(Cured for 30min@150°C)
|Typical Value||Test Standard|
|Surface resistance (Ω)||3.5×1016||GB/T1410-2006|
Direction For Use
The product should be recovered to room temperature before use, don't open the aluminum foil package before recovered to room temperature(the recovering time of 300ml packaging at least 2-4 hours).
The product should be used at 25°C ,
The glue viscosity will decline under the higher temperature, which influence printing effect; High humidity can increase the glue of moisture absorption which shorten the opening hours of the glue and influence the glue bonding strength. This product opening time is 48 hours at 25 °C,55% Rh.
Suggest to print at the speed of 20-150 mm/s; Drawknife pressure is 3-4 N/cm (Afer scraping, sheet should be clean, and avoid producing wire drawing); the deviating speed from the sheet is 0.1-3.0 mm/s.
Not cured adhesive which is stick on line wires can be erased with acetone or propylene alcohol ethers.
Please seal and chill when not using up the glue.
Keep away from children.
The workshop should be adequate ventilation.
Wash with soapy water if on skin.
Wash with a lot of soapy water and then go for doctor if in eyes.
For more information, please refer to MSDS.
SMT red plastic 120-150 degree curing adhesive for posts 30CC
light amber to colorless and transparent liquid
UV lamp/UV light
1. Make sure the glass is clean and dry.
2. In order to ensure the stability of product, blow the glass surface make sure it is dry without moisture, in winter construction
3. The product is irritated to eye and skin. Thoroughly flush the eyes with water at least 20 minutes, and seek medical attention, if splashed in eyes incaution
4. Only for industrial use, please refer to instructions and Material Safety Data Sheet for health and safety